HPE0-V15 Delta - Building HPE Hybrid IT Solutions Questions and Answers

Why is SNMPv2c considered to be insecure?

Exhibit:

Which HPE ProLiant Server meets the customer's requirements?

Which HPE ProLiant Server meets the customer's requirements?

A customer needs a low cost block storage array for targeted workloads. The array needs to provide automated tiering, thin provisioning, and snapshot capabilities.

Which HPE storage solution meets the customer requirements?

Which feature in a block storage array eliminates redundant data through the process of using indexes that refer to the original set of data?

An administrator has two switches connected with a single link. The administrator observes that, during hours of peak activity, the storage traffic tends to consume the link. The link is shared with other types of traffic that is time sensitive.

What technology can the administrator use to help alleviate the situation while they are working towards a long-term solution?

A customer is subject to regulatory requirements and their data is highly sensitive.

Which HPE Smart Array feature addresses their need for an level of security for data stored inside their server?

Read the question, and then refer to the exhibit.

display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0

An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.

The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.

What must you do to resolve this issue?

Which HPE Proliant server should you recommend for a home office environment where the server will be located in the same office as the user?

For which virtualization management products does HPE OneView offer integration plug-ins1? (Select two.)