1z0-404 Oracle Communications Session Border Controller 7 Basic Implementation Essentials Questions and Answers

Navigate to the policy-attribute configuration element and configure the from-address parameter to match the Request-URI value.

Navigate to the policy-attribute configuration element and configure the to-address parameter to match the Request-URI value.

Navigate to the local-policy configuration element and configure the from-address parameter to match the Request-URI value.

Navigate to the local-policy configuration element and configure the to-address parameter to match the Request-URI value.

Navigate to the local-policy configuration element and configure the destination-address parameter to match the Request-URI value.

the Session Border Controller will never use the SIP-NAT mechanism for routing

the Session Border Controller will not use the registration cache for routing

all endpoints in the realm will be cached when registered

only endpoints behind NAT in the realm will be cached when registered

the Session Border Controller will never use the local-policy mechanism for routing

Navigate to the sip-port configuration element and set the allow-anonymous parameter to realm-prefix.

Navigate to the session-agent configuration element and set the ip-address parameter to the IP address of your trusted User Agent (UA).

Navigate to the sip-port configuration element and set the allow-anonymous parameter to agents-only.

Navigate to the sip-port configuration element and set the allow-anonymous parameter to all.

Navigate to the realm-config configuration element and set the addr-prefix parameter to the IP subnet of your trusted User Agents (UAs).

the IP utility address and its virtual MAC address

the virtual IP address and its hardcoded MAC address

the IP utility address and its hardcoded MAC address

the virtual IP address and its virtual MAC address

the IP utility address and the MAC utility address

The default community strings are acme and packet.

The default community strings are public and private.

Community strings are in passive mode.

There are no default community strings.

Only one trap receiver can be configured.

Navigate to the network-interface configuration element and set the sub-port-id parameter to 12.

Navigate to the network-interface configuration element and set the sub-port-id parameter to 0.

Navigate to the phy-interface configuration element and configure the hip-id parameter.

Navigate to the phy-interface configuration element and configure the pri-utility-address parameter.

Navigate to the network-interface configuration element and configure the name parameter.

A phy-interface element must be configured for each interface used for High Availability (HA) heartbeats, but not for signaling and/or media.

After configuring a phy-interface configuration element for signaling and/or media, a reboot of the Session Border Controller is required.

A phy-interface configuration element must be configured for each interface used.

A unique phy-interface configuration element is created for all signaling/media interfaces.

A phy-interface configuration element for signaling and/or media has the operation-type parameter set to control.