1Y0-231 Deploy and Manage Citrix ADC 13 with Citrix Gateway Questions and Answers

What can a Citrix Administrator configure to filter IPv4 addresses?

Scenario: A Citrix Administrator needs to test a SAML authentication deployment to be used by internal users while accessing several externally hosted applications. During testing, the administrator notices that after successfully accessing any partner application, subsequent applications seem to launch without any explicit authentication request.

Which statement is true regarding the behavior described above?

The Citrix ADC SDX architecture allows instances to share _____________ and _____________. (Choose the two correct options to complete the sentence.)

Scenario: A Citrix Administrator configured the policies below:

POLICY 1:

add rewrite action ACT_1 corrupt_http_header Accept-Encoding

add rewrite policy POL_1 HTTP.REQ.IS_VALID ACT_1

POLICY 2:

add rewrite action ACT_2 insert_http_header Accept-Encoding “\”identity\””

add rewrite policy POL_2 “HTTP.REQ.IS_VALID” ACT_2

Which set of commands can the administrator use to bind the rewrite policies to the LB vserver lb_vsrv so that

POL_2 is evaluated after POL_1 is evaluated successfully?

Scenario: A Citrix Administrator made changes to a Citrix ADC, deleting parts of the configuration and saving some new ones. The changes caused an outage that needs to be resolved as quickly as possible. There is no Citrix ADC backup.

What does the administrator need to do to recover the configuration quickly?

Scenario: Users are attempting to logon through Citrix Gateway. They successfully pass the Endpoint Analysis (EPA) scan, but are NOT able to see the client choices at logon.

What can a Citrix Administrator disable to allow users to see the client choices at logon?

Scenario: A Citrix Administrator configured a new router that requires some incoming and outgoing traffic to take different paths through it. The administrator notices that this is failing and runs a network trace. After a short monitoring period, the administrator notices that the packets are still NOT getting to the new router from the Citrix ADC.

Which mode should the administrator disable on the Citrix ADC to facilitate the successful routing of the packets?