150-130 Brocade Certified Network Engineer 2012 Questions and Answers

You are configuring multiple VLANs using only untagged ports on two switches. Which statement is true?

Which version of Simple Network Management Protocol (SNMP) supports the Advanced Encryption Standard (AES)?

A client had ports 1/3/1 and 1/3/2 on the Brocade FCX go down because of errors being received from the upstream switch. The client repaired the upstream switch but the ports of the FCX are still down.

Referring to the command output shown above, what does the client need to do to bring up the links?

An identical route has been discovered by OSPF and RIP. By default, the OSPF route is chosen and added to the routing table. What should be done to allow the RIP route to be preferred?

A customer uses an access control list (ACL) to restrict access to servers on their network. The

ACL properly restricts traffic. However, the customer has no visibility to which IP addresses were denied by the ACL. Which word added to the end of the ACL statement would solve this problem?

You have been informed a group of remote employees are unable to authenticate with the RADIUS server. From the Brocade FCX router, you enable the debug dot1x events command.

Which three events will be viewed? (Choose three.)

Which two access control list (ACL) types will match on TCP/UDP ports? (Choose two.)

You have configured your Brocade device as shown in the exhibit.

Brocade#sh ip

Switch IP address: 10.200.128.116

Subnet mask: 255.255.255.0

Default router address: 10.200.128.1

TFTP server address: 10.200.46.57

Configuration filename: Brocade

Image filename: None

IP MTU: 1500

Brocade#traceroute 10.200.128.1

Type Control-c to abort

Tracing the route to IP node 10.200.128.1 from 1 to 30 hops

1 <1 ms <1 ms <1 ms 10.200.128.1

Which statement is correct regarding interface Ethernet 10 on this device having inbound traffic from 172.17.1.1/24 to 172.17.2.1/24 on port 21?

What are two functions of an OSPF Autonomous System Boundary Router (ASBR)? (Choose two.)

Which two results does the link-aggregate configure key command accomplish when creating Link Aggregation Groups (LAGs) on a FastIron device? (Choose two.)

You need to troubleshoot problems with an optic connection on a Brocade MLXe device.

What information is displayed by show optic for each port on that slot? (Choose three.)

What are two Brocade products that are designed for use in a service provider network? (Choose two.)

During the discovery process, to which registered multicast IP address does OSPF send a hello packet?