Black Friday Early Access - 75% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save75geek

H35-831 HCIE-Datacom-Carrier (Written) V1.0 Questions and Answers

Questions 4

Which of the following are applications of BFD in a 5G transport network?

Select all that apply.

Options:

A.

BFD is enabled for TE tunnels to trigger VPN FRR.

B.

BFD is enabled between IGP peers to trigger SR-BE FRR.

C.

BFD is enabled for TE LSPs to trigger TE hot standby.

D.

BFD for interface can be enabled on core devices and the core network side to trigger VRRP or active/standby route switching.

Buy Now
Questions 5

OSPF NSR is implemented by synchronizing protocol running data from the active main control board to the standby main control board in real time. Which of the following data can be synchronized from the active main control board to the standby main control board in real time?

Select all that apply.

Options:

A.

Shortest path tree information

B.

Routing table

C.

Configuration data

D.

LSDB

Buy Now
Questions 6

In the inter-AS VPN Option B network shown, Site1 and Site2 can communicate. CE1 has a route to 10.1.1.1/24, and CE2 has learned that route. PE1, ASBR1, and ASBR2 assign VPN labels 15360, 15361, and 15362, respectively, to the route. In addition, PE1 and ASBR2 assign public-network label 3 to their own loopback interface addresses. For packets sent from CE2 to 10.1.1.1, which label pushed by PE2 is the innermost label?

Exhibit 46.1 — Original topology/configuration figure

Options:

A.

15362

B.

3

C.

15360

D.

15361

Buy Now
Questions 7

The figure depicts an inter-AS EVPN Option B network and the EVPN configuration between ASBR2 and PE2. Which device is the next hop for the route that ASBR2 advertises to PE2?

Exhibit 54.1 — Original topology/configuration figure

Options:

A.

ASBR2

B.

ASBR1

C.

PE1

D.

P2

Buy Now
Questions 8

Which of these statements is incorrect regarding SRv6 SFC?

Options:

A.

SRv6-aware SFs can identify and process received SRv6 packets.

B.

SRv6-unaware SFs can implement the SFC functionality without requiring SF proxy configuration.

C.

SRv6-unaware SFs cannot identify SRv6 packets and therefore discard them upon receipt.

D.

The SIDs of SRv6-aware SFs can be directly orchestrated into SFC paths to implement the SFC functionality.

Buy Now
Questions 9

Which of the following statements about BGP RRs is incorrect?

Options:

A.

Fully meshed IBGP connections need to be established between non-clients.

B.

A maximum of three levels of RRs can be deployed.

C.

The routes learned from EBGP peers are advertised to all clients and non-clients.

D.

RRs in different clusters need to establish fully meshed IBGP connections to learn routes from each other.

Buy Now
Questions 10

Which of the following statements are accurate regarding router ID planning in a 5G transport network?

Select all that apply.

Options:

A.

Addresses must be properly reserved at each layer to prevent re-planning required for network expansion.

B.

It is recommended that router IDs on the same ring be consecutive and use 32-bit host addresses.

C.

Two devices on the transport network cannot use the same router ID.

D.

In address planning, it is good practice to make each address meaningful. In this way, you can roughly determine the location and services of a device based on an address.

Buy Now
Questions 11

A device receives two BGP routes for the same prefix from two peers, with one route received from each peer. One route has next hop NH1, whereas the other has next hop NH2. All other attributes of the two routes are identical. NH1 recursively resolves to two direct next hops, A and B, and NH2 likewise recursively resolves to two direct next hops, C and D. If BGP is configured with the maximum load-balancing 2 command and the device supports at most six load-balancing routes, how many load-balancing routes for the relevant prefix are present in the FIB?

Options:

A.

4

B.

2

C.

3

D.

1

Buy Now
Questions 12

The topology shown is a typical transport-network access-layer structure. Each core-network device is dual-homed to two CEs, and the CEs and PEs are interconnected in a square-loop topology. The access layer must carry voice and signaling services. Two VPN instances must be configured on each CE to isolate voice services from signaling services and provide security and QoS. Signaling services are transmitted in active/standby mode, while voice services are transmitted in load-balancing mode. VRRP must be enabled between the two CEs to terminate signaling flows. From the perspectives of network robustness and architectural suitability, which statements about this topology are correct?

Exhibit 60.1 — Original topology/configuration figure

Select all that apply.

Options:

A.

GE links, not POS links, should be used between CEs and PEs.

B.

GE and FE links between two CEs need be added to an Eth-Trunk to improve reliability.

C.

The total bandwidth of the link between two CEs should be greater than or equal to the bandwidth of the CE-PE interconnection link.

D.

The voice services should be carried on GE links, and the signaling services should be carried on FE links.

Buy Now
Questions 13

Which backup modes do vBRAS-UPs support?

Select all that apply.

Options:

A.

N+1 warm backup

B.

N+1 hot backup

C.

N:1 cold backup

D.

N:1 warm backup

Buy Now
Questions 14

Which statements about the backbone-network solution model for an IP transport network are correct?

Select all that apply.

Options:

A.

If RRs are deployed on the transport network, all PEs need to establish BGP peer relationships with the RRs.

B.

If no RR is deployed, PEs do not need to establish full-mesh BGP peer relationships.

C.

If multiple clusters are planned on the IP transport network, full-mesh BGP peer relationships need to be established between RRs in different clusters.

D.

If RRs are deployed on the transport network, IBGP peer relationships need to be established between PEs.

Buy Now
Questions 15

Which of the following statements are accurate about the SR Policy configuration shown?

Exhibit 33.1 — Original topology/configuration figure

Select all that apply.

Options:

A.

CP2 is the primary path of the SR Policy.

B.

Traffic destined for 3.3.3.3 can recurse to the SR Policy.

C.

Traffic with the next hop 3.3.3.3 can recurse to the SR Policy.

D.

The color value is transmitted through a BGP route.

Buy Now
Questions 16

Which of the following statements regarding EVPN on a 5G transport network is incorrect?

Options:

A.

EVPN L3VPN routes appear only in the EVPN routing table, not in the display bgp vpnv4 all routing-table command output.

B.

In the IP VPN instance of each device, the RT needs to be changed to be advertised in the EVPN address family.

C.

If EVPN is used to carry L3VPN services, you must run the advertise l2vpn evpn command in the BGP-VPN instance IPv4 address family view. Otherwise, routes are advertised through VPNv4 by default.

D.

When SR tunnels are used to carry EVPN traffic, the evpn mpls routing enable command must be run in the VPN instance view.

Buy Now
Questions 17

Which of the following statements are true regarding multicast packets in a BIERv6 multicast network?

Select all that apply.

Options:

A.

The destination nodes of a multicast packet can belong to only one set.

B.

The destination nodes of a multicast packet can belong to multiple sets.

C.

Only one copy of multicast packets can be transmitted over one link on the multicast network.

D.

Multiple copies of multicast packets can be transmitted over one link on the multicast network.

Buy Now
Questions 18

Which statements correctly describe the MVPN route types used in the MVPN over BIERv6 solution?

Select all that apply.

Options:

A.

When a receiver PE receives a PIM (C-S, C-G) Join or Prune message, it converts the message into a Leaf A-D route.

B.

Both sender and receiver PEs can send Intra-AS I-PMSI A-D routes.

C.

Intra-AS I-PMSI A-D routes are used to discover MVPN members and establish I-PMSI tunnels.

D.

Both sender and receiver PEs can send S-PMSI A-D routes.

Buy Now
Exam Code: H35-831
Exam Name: HCIE-Datacom-Carrier (Written) V1.0
Last Update: Nov 20, 2026
Questions: 60
H35-831 pdf

H35-831 PDF

$22.5  $89.99
H35-831 Engine

H35-831 Testing Engine

$28.75  $114.99
H35-831 PDF + Engine

H35-831 PDF + Testing Engine

$35  $139.99